16Channel 12bit PWM Servo Driver I2C Interface PCA9685 for Arduino DIY Servo Shield Module


In stock


In stock

A product for Arduino that works with official Arduino boards.

– This is a i2c-controlled PWM driver board with a built-in clock, which is quite different from TLC5940 series. You don’t need to continuously send signals and occupy your MCU.

– 5V compatibility, which means that you can use 3.3V MCU to control and drive the output up to 6V (when you want to control the white or blue indicator light, 3.4V+ is also OK).

– 6 address select pins allow you to connect 62 driver boards to one i2C bus, total 992 channels of PWM output.

– About 1.6KHz frequency modulation PWM output.

– Get 12-bit resolution output ready for stepping motor, which means that the 60Hz update rate can reach to 4us resolution.

– Configurable totem-pole output or open-collector output.

– Output enable pin can quick disable all outputs.

– PCA9685 chip is at the center of the board.

– With power input terminal.

– With green power indicator light.

– Convenient to insert total 16 servos at the same time (the plug of servo is a little large than 0.1″, so you can put 4 pairs of 0.1″ connectors).

– With reverse polarity protection for input.

– Cascade design.

– Put a bulky capacitor on the V+ line (sometimes you need it).

– Put 220 ohm resistance components onto all PWM output lines, so as to protect them, and you can easily drive the LED.

Based on 0 reviews

0.0 overall

Only logged in customers who have purchased this product may leave a review.

There are no reviews yet.


We are glad that you preferred to contact us. Please fill our short form and one of our friendly team members will contact you back.